So I got the snorkel together I just need to extend the breather lines and paint the pvc. I didn't want something permanent so I was able to make it where I can take it apart pretty fast and I didn't cut the plastic.

You got a pretty bike there pal.

Neat, you plan on doing some pretty deep water riding?

Yeah, why'd ya go so high with it? Looks like its gonna grab every branch along the trail till it breaks off! LOL!! Good luck with that set up.LOL!!

i like the counterweight on the seat. ballast to keep her on the ground?

My buddy does the same thing with the weights for plowing snow.

The weights are for plowing. The reason its up high is since its right above the wheel I was worried about the tire throwing junk up and getting sucked in. Rich yeah I wanna try to do some swimming with it lol. Thanks 250 I've had her for almost 9 years, this quad never gives up. I have the 450 shocks on it now and I'm gonna put my raptor shocks on it to lift it up. I know it dosnt have the power like the big 4X4s but its a lot lighter so I can get though the rough stuff a lot easier.

Hows it run? I remember on a Arctic Cat website that guys with the 400's had to rejet the carb if they ran 2" PVC. Is that 2"? Looks big in the pics for 1 1/2" PVC.

I havn't had it out of the garage yet. I did start it up and it ran fine. It's mostly 2" but off the top of the box it's 1 1/2 for about a foot then I went to 2" due to the bends and lenth of pipe I used. I couldn't use all 2" cause I couldn't fine 2" flexable pipe.

Make sure you take every electrical connection on that wheeler and put dialectric grease inside of them and plug em back together. Water + electrical = Disaster. Trust me. Other than that you got your basis covered.